SET-1000 12 VDC
D15648_E-2
Installation and Operating Instructions
Copyright © 2019 Labkotec Oy
6/14
We reserve the right for changes without notice
2.2
Cabling when using cable joint
Figure 5. Cable joint
Connections of the sensor cable inside the cable joint are explained in
figure 8. Cable shields and possible excess wires need to be connected
to the same point in galvanic contact.
Please make sure, that the sensor and cable between SET-1000
control unit and the sensor do not exceed the maximum allowed
electrical parameters
– see appendix 1 Technical data.
IP rating of the cable joint is IP68. Make sure, that the cable joint is
closed properly.
If the sensor cable must be extended and there is a need for
equipotential grounding, it should be done with the junction box LJB2.
The cabling between the SET-1000 control unit and the junction box
should be done with a shielded twisted pair instrument cable.
Figure 6.
Cable installation example
Figure 7.
Installation accessories
Figure 8.
Level sensor cabling with a
cable joint for cable extension.
Summary of Contents for SET-1000 12 VDC
Page 14: ......
