The control unit display shows the message
"
Detecting sensors, 0 sensor(s) found"
and
three dots begin cycling at the bottom of the
display.
Figure 15. Sensor identification.
Depending on how many sensors are
connected to the control unit, the display
may show the following message, for
example:
"Detecting sensors, 3 sensor(s)
found".
Figure 16. Three sensors found.
Once all sensors have been identified, the
display shows the message:
SYSTEM OK
.
The idOil separator alarm system is now
operational at factory settings.
Figure 17. All sensors found.
If the control unit does not identify all connected sensors.
Check the sensor connections.
After the check, press the sensor identification button again.
The control unit will look for the sensors for approx. 2 minutes, unless it has already found
three sensors.
The sensor identification can be stopped by pressing the sensor identification button for 5
seconds.
Installation and Operating Instructions | idOil Solar
20/58
DOC001599-EN-3
