LabelStation Pro 240
Page 61 of 67
The SD Card is
inoperable.
The SD Card
is damaged or
not inserted
correctly. The
card is not of
an approved
type.
Check the card is inserted correctly and/or try it in another device.
Check the card’s specification.
Poor print
quality.
Ribbon and/or
media loaded
incorrectly.
Dust or
adhesive has
accumulated
on the print-
head.
Print density
and speed not
optimised.
Print-head has
damaged
elements.
Ribbon and
media are
incompatible.
The print-head
pressure is not
adjusted for
best results.
* Reload the supply.
* Clean the print-head.
* Clean the platen roller.
* Adjust the print density and print speed.
* Run printer self-test and check the print head test pattern if there is
dot missing in the pattern.
* Change proper ribbon or proper label media.
* Adjust the print-head pressure adjustment knob.
- If the left side printout is too light, please adjust the left side
pressure adjustment knob to the higher index (higher pressure). If the
pressure adjustment knob has been adjust to index “5” and the poor
print quality is still at the left side of the printout, pressure adjustment
knob to index “1” and use the Z-axis adjustment knob to fine tune the
pressure.
- If the right side printout is too light, please adjust the right side
pressure adjustment knob to the higher index (higher pressure) If the
pressure adjustment knob has been adjust to index “5” and the poor
print quality is still at the right side of the printout, pressure
adjustment knob to index “1” and use the Z-axis adjustment knob to
fine tune the pressure.
* The release lever does not latch the print-head properly.
LCD unlit but
LEDs
illuminated.
Printer
initialisation
unsuccessful.
Re-initialise the printer. Switch printer off briefly.
LCD unlit, LEDs
illuminated,
label issuing
from the printer.
LCD cable
connector
loose or
plugged in
upside down.
Connect the cable correctly.
Cutter not
working.
Cutter
connector
loose
Connect the cable correctly.
Label drifting
sideways
causing
misaligned
print.
Label guide
not adjusted to
edge of label.
Adjust position of label guide until label cannot be moved sideways.
