LABEL-AIRE Write-up 3138NV-DAT, Manual

Page: 24 / 53

24
7. Divide the distance "A" by the conveyor speed per second. The resulting number is the approximate
LABEL ON PRODUCT POSITION.
Use the [UP] and the [DOWN] buttons to set the LABEL ON PRODUCT POSITION to slightly more than the
calculated number.
8. Set the swing tamp air regulator to zero.
SPECIFIC MODE
9.
Manually extend the swing tamp.
Measure the distance from Product Detector #2
to just beyond the fully extended swing tamp.
Record the distance "B".
NORMAL MODE
9.
Manually extend the swing tamp.
Measure the distance from Product Detector #1
to just beyond the fully extended swing tamp.
Record the distance "B".
Distance "B" is slightly greater than the distance that the product will travel during the SECOND LABEL
POSITION time.
Figure 10 Label Placement Side & Rear
10.
Divide measurement “B” by the conveyor speed per second. The resulting number is the
approximate second Label position.