Chapter 3: Getting Started
Product Service 1-800-522-7658
9
Original instructions
IF YOUR STOPPERING TRAY DRYER WAS DAMAGED IN
TRANSIT, YOU MUST FILE A CLAIM DIRECTLY WITH THE
FREIGHT CARRIER. LABCONCO CORPORATION AND ITS
DEALERS ARE NOT RESPONSIBLE FOR SHIPPING DAMAGE.
DO NOT DISCARD THE CARTON OR PACKING MATERIAL
FOR YOUR STOPPERING TRAY DRYER UNTIL YOU HAVE
CHECKED ALL OF THE COMPONENTS AND INSTALLED
AND TESTED THE STOPPERING TRAY DRYER.
Stoppering Tray Dryer Components
Verify that the components listed below are present and undamaged.
Qty
Part #
Description
Comments
1
794801***
Stoppering Tray Dryer
1
1089005
User’s Manual
USB Flash Drive
1
Power Cord
See parts list (Appendix A)
1
7364601
Communication Cable
3
7365800
Sample Temp Sensor
8
1911416
Washer, ¼”
4
1905621
Nut, ¼ - 20
4
1880712
Screw, ¼ - 20 x .75 long
If you did not receive one or more of the components listed for your Stoppering
Tray Dryer, or if any of the components are damaged, contact Labconco
Corporation immediately for further instructions.
Setting Up Your Stoppering Tray Dryer
After you verify receipt of the proper components, move your Stoppering Tray
Dryer to the location where you want to install it. Then, follow the steps listed
below.
Installing the Stoppering Tray Dryer on a Console
Freeze Dryer
The following tools are required to install the Stoppering Tray Dryer onto a
FreeZone Console Freeze Dry: Flat blade screwdriver or 5/16" socket, and a
7/16" wrench or socket.
1.
Remove the four plastic hole plugs from the top of the Freeze Dryer on
which the Stoppering Tray Dryer is to be mounted.
2.
If the Freeze Dryer has a flat gasket around the 3.0 inch vacuum port,
remove it.
