28
English
6.1 Serving of espresso coffee
1) Remove the filter-holding cup from the serving unit and fill it with a dose of ground coffee (filter cup with
one spout) or with two doses of ground coffee (filter cup with two spouts). Press the ground coffee using
the relative coffee presser and then insert the filter cup into the serving unit.
2) Place one or two cups under the serving spouts.
3) Pull down the lever 6 and then let it return to its original position. The coffee will begin to flow after a short
time. To obtain a greater quantity of coffee repeat this operation.
Note: Make sure that serving into the cup has taken place correctly. If serving has not occurred correctly, see
the chapter “PROBLEMS AND SOLUTIONS”.
MANDATORY REQUIREMENTS: the operation of the lever for coffee brewing, it is extreme-
ly dangerous. In order to avoid the risk of harm to the operator is absolutely necessary,
before driving the lever for any reason, make sure that:
1. the filter holder cup is completely filled with the right amount of coffee,
2. the cup is safely and properly coupled to the coffee brewing unit and
3. the coffee machine is regularly and properly connected to the network‘s national water, with the
water shutoff valve fully open.
It ‘still strict obligatory for the user of the lever machine keeping the body at a minimum distance
of 30 cm from the range of lever’s action when the lever is operating, as well as shown in Figure A.
The manufacturer declines all responsibilities for any damage occurring to persons and / or prop-
erty due to negligent behaviour by the user that does not comply with the mandatory require-
ments contained in this manual.
Should the cup not properly couple the group brewing unit , is strictly forbidden to continue to
use the machine in such conditions and it is imperative to contact your nearest authorized service
center or the manufacturer, La San Marco SpA.
6.2 Drawing steam
A jet of steam, which can be used to foam milk or to heat other liquids, comes out of the steam drawing spout
as follows: by raising or lowering the lever you attain the maximum flow (the lever stops in the maximum po-
sition. To stop the flow of steam, place the lever back in its original position).
The steamer must be used with care: the contact of the skin with the steam spout or with the jet
of steam itself can cause serious burns. Grip the anti-burn sheath to change the position of the
steam drawing spout. Never aim the jet of steam at persons or at objects which do not have to
do with the use as described in this manual.
Note: Before using the spout for drawing steam, drain out into the tub any condensation which may have
formed in it. After using the spout, clean it properly with a moist cloth, and if necessary discharge any residue
remaining inside it into the tray.
