7
2.
Within 1-1/2 minutes of activating the Projection clock, place 2 x AA, IEC LR6, 1.5V batteries into
the transmitter.
3.
After a few seconds of inserting the batteries into the transmitter, the projection clock will start
receiving data from the transmitter. The remote temperature will then be displayed on the clock. If
this does not happen after 2 minutes, the batteries will need to be removed from both units and reset
from step 1.
4.
In order to ensure sufficient 433 MHz transmission however, this should under good conditions be
no more than 25 metres from where the Projection clock will be finally positioned (see notes on
“
POSITIONING THE OUTDOOR TRANSMITTER
” and “
433 MHZ RECEPTION
”).
5.
Use the MODE/ MIN key to manually enter a time (and date) initially.
Note:
Should the total time of inserting the batteries into the transmitter take longer than 1-1/2 minutes from the
time of inserting the batteries into the projection clock then temperature reception problems may occur. If
the temperature is not being received, then see "
433 MHZ RECEPTION
", before resetting the units.
In the event of changing batteries to the transmitter, the projection clock needs to be reset. (See
RESETTING THE PROJECTION CLOCK
)
