4
TO USE THE WEATHER PROJECTION STATION POWER ADAPTER
The unit comes with an AC adapter for using the projector for an extended period of time, such as
throughout the night.
To connect the AC adapter:
Important!
Make sure that your household voltage is 120V! Otherwise it can result in damaging your weather
projection station.
1.
Connect the AC adapter to a wall socket. Plug the adapter into the jack on the back of the weather
projection station. All segments of the LCD will light up briefly and a short signal tone will sound. Then
the ALM 1 6:00, the indoor temperature and humidity, the time as 12:00, the date as WE 1.1and the
weather icons will be displayed. If the indoor temperature and indoor humidity are not displayed after
15 seconds, remove the batteries and wait for at least 3 minutes before reinserting them.
2.
Within 4 minutes of activating the weather projection station, place the batteries into the remote
temperature/humidity sensor (see “
To install and replace batteries in the remote
temperature/humidity sensor
“).
3.
After inserting the batteries into the remote temperature/humidity sensor, the weather projection
station will start receiving data from the remote temperature/humidity sensor. The outdoor
temperature and humidity should then be displayed on the weather projection station. If this does not
happen after 3 minutes, the batteries will need to be removed from both units and reset from step 1.
4.
The weather projection station can receive up to 3 remote temperature/humidity sensors. If you have
purchased additional remote temperature/humidity sensors, repeat from step 3 for all extra remote
temperature/humidity sensors. However, ensure that you leave 10 seconds in between the reception
of the last remote temperature/humidity sensor and the set-up of the following remote
temperature/humidity sensor. The weather projection station will number the remote
temperature/humidity sensors in the order of set-up, i.e. the first remote temperature/humidity sensor
will have the temperature/humidity displayed with the number 1 against it and so on.
5.
With less than 3 remote temperature/humidity sensors received, the weather projection station will try
to pick up the remaining one in approximately another 3 minutes. If 3 remote temperature/humidity
sensors are received, the weather projection station will stop further reception.
6.
Once the outdoor temperature and the humidity have been received and displayed on the weather
projection station, the WWVB time code reception is automatically started. This takes typically
between 6-8 minutes in good conditions.
7.
If after 10 minutes, the WWVB time has not been received, use the SET key to manually enter a time
initially. The clock will automatically attempt to receive the WWVB time from 12:00 to 6:00 a.m. for a
successful reception. When WWVB reception signal is successful, the received time will override the
manually set time. The date is also updated with the received time. The next reception attempt will
occur on the following day. (Please refer to notes on
“About WWVB Radio controlled Time”
and
“Manual Time Setting”
).
Your weather projection station is now operational!
