2
•
Can receive up to 3 remote temperature/humidity sensors
•
Time projection display (hour and minute)
•
Outdoor temperature projection display (degrees ºF or ºC)
•
Alternate projection display mode selectable
•
Projection with adjustable brightness and projection orientation possible
•
LCD contrast selectable
•
E.L.
back
light
•
Low battery indicator
•
Table
standing
•
AC/DC power adapter included
The Remote Temperature/Humidity Sensor
•
Remote transmission of outdoor temperature and humidity to weather projection station by 433 MHz
•
Rain proof casing
•
Wall mounting case
•
LCD display of temperature and humidity readings
TO INSTALL AND REPLACE BATTERIES IN THE WEATHER PROJECTION STATION
The weather projection station uses 3 AA batteries. To install and replace
the batteries, please follow the steps below:
1.
Push down on the top center of the battery cover and pull away
from the unit to remove the cover.
2.
Insert batteries observing the correct polarity (see marking).
3. Replace
compartment
cover.
TO INSTALL AND REPLACE BATTERIES IN THE REMOTE TEMPERATURE/HUMIDITY
SENSOR
The remote temperature/humidity sensor uses 2 AA batteries. To install and replace the
batteries, please follow the steps below:
1.
Remove the battery cover.
2.
Insert the batteries, observing the correct polarity (see marking).
3.
Replace the battery cover on the unit.
Note:
In the event of changing batteries in any of the units, all units need to be reset by
following the set-up procedures. This is due to a random security code assigned by the
remote temperature/humidity sensor at start-up. This code must be received and stored by
the weather projection station in the first 3 minutes of power being supplied to the remote
temperature/humidity sensor.
Table stand/wall
mount bracket
