for different working environments. The indoor sensor
is less responsive to ambient air currents because of
the shielding effect of the display’s case. In addition,
the case can act as a heat sink to absorb and store
heat from external sources (i.e. handling of the case or
radiant heat). Also, the much greater range of the re-
mote temperature sensor requires a different calibra-
tion curve than the indoor range. Error is usually greater
at the extreme ends of a range, making it harder to
compare different ranges with different curves. Under
non-laboratory conditions, it is difficult to compensate
for the above factors and obtain an accurate
comparison.
MAINTENANCE AND CARE INSTRUCTIONS
•
Extreme temperatures, vibration, and shock should
be avoided to prevent damage to the units.
•
Clean displays and units with a soft, damp cloth.
Do not use solvents or scouring agents; they may
mark the displays and casings.
•
Do not submerge in water.
•
Immediately remove all low powered batteries to
avoid leakage and damage.
•
Opening the casings invalidates the warranty. Do
not try to repair the unit. Contact La Crosse Tech-
nology for repairs.
SPECIFICATIONS
Temperature measuring range:
Indoor:
14.1˚F to 139.8˚F with 0.2˚F resolution.
“OFL” displayed if outside this range.
Outdoor:
-39.8˚F to 139.8˚F with 0.2˚F resolution.
“OFL” displayed if outside this range.
Indoor relative humidity
measuring range:
1% to 99% with 1% resolution.
(“- -” displayed if outside this range.
Indoor Temperature
checking interval:
Every 15 seconds.
Outdoor Temperature checking interval
(Remote Control Sender):
Every 4 seconds.
Transmission Range:
330 feet (in open space).
Power Supply:
Weather Station:
2 x AA, IEC LR6, 1.5V.
Temperature Transmitter:
2 x AAA, IEC LR3, 1.5V.
Battery life cycle:
Approximately 24 months.
Recommended battery type:
Alkaline.
Dimensions (L x W x H)
Weather Station:
2.91" x 1.15" x 3.86"
(74 x 29.1 x 98mm).
Temperature Sensor:
1.44" x 0.76" x 4.80"
(36.6 x 19.3 x 121.8 mm)
WARRANTY INFORMATION
La Crosse Technology, Ltd provides a 1-year limited
warranty on this product against manufacturing defects
in materials and workmanship.
This limited warranty begins on the original date of
purchase, is valid only on products purchased and used
in North America and only to the original purchaser of
this product. To receive warranty service, the purchaser
must contact La Crosse Technology, Ltd for problem
determination and service procedures. Warranty ser-
vice can only be performed by a La Crosse Technology,
Ltd authorized service center. The original dated bill
of sale must be presented upon request as proof of
purchase to La Crosse Technology, Ltd or La Crosse
Technology, Ltd’s authorized service center.
La Crosse Technology, Ltd will repair or replace this
product, at our option and at no charge as stipulated
herein, with new or reconditioned parts or products if
found to be defective during the limited warranty pe-
riod specified above. All replaced parts and products
become the property of La Crosse Technology, Ltd and
must be returned to La Crosse Technology, Ltd. Re-
placement parts and products assume the remaining
original warranty, or ninety (90) days, whichever is
longer. La Crosse Technology, Ltd will pay all expenses
for labor and materials for all repairs covered by this
warranty. If necessary repairs are not covered by this
warranty, or if a product is examined which is not in
need or repair, you will be charged for the repairs or
examination. The owner must pay any shipping charges
incurred in getting your La Crosse Technology, Ltd prod-
uct to a La Crosse Technology, Ltd authorized service
center. La Crosse Technology, Ltd will pay ground re-
turn shipping charges to the owner of the product to a
USA address only.
Your La Crosse Technology, Ltd warranty covers all
defects in material and workmanship with the following
specified exceptions: (1) damage caused by accident,
unreasonable use or neglect (including the lack of rea-
sonable and necessary maintenance); (2) damage
occurring during shipment (claims must be presented
to the carrier); (3) damage to, or deterioration of, any
accessory or decorative surface; (4) damage resulting
from failure to follow instructions contained in your
owner’s manual; (5) damage resulting from the perfor-
mance of repairs or alterations by someone other than
an authorized La Crosse Technology, Ltd authorized
service center; (6) units used for other than home use
(7) applications and uses that this product was not in-
tended or (8) the products inability to receive a signal
due to any source of interference.. This warranty cov-
ers only actual defects within the product itself, and
does not cover the cost of installation or removal from
a fixed installation, normal set-up or adjustments, claims
based on misrepresentation by the seller or perfor-
mance variations resulting from installation-related
circumstances.
LA CROSSE TECHNOLOGY, LTD WILL NOT AS-
S U M E L I A B I L I T Y F O R I N C I D E N TA L ,
CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR
DAMAGES ASSOCIATED WITH THE OPERATION OR
MALFUNCTION OF THIS PRODUCT. THIS PROD-
UCT IS NOT TO BE USED FOR MEDICAL PUR-
POSES OR FOR PUBLIC INFORMATION. THIS
P RO D U C T I S N OT A TOY. K E E P O U T O F
CHILDREN’S REACH.
This warranty gives you specific legal rights. You may
also have other rights specific to your State. Some
States do no allow the exclusion of consequential or
incidental damages therefore the above exclusion of
limitation may not apply to you.
For warranty work, technical support, or information
contact:
La Crosse Technology
2809 Losey Blvd. South
La Crosse, WI 54601
Phone: 608.782.1610
Fax: 608.796.1020
e-mail:
(warranty work)
(information on other products)
web:
www.lacrossetechnology.com
Questions? Instructions? Please visit:
www.lacrossetechnology.com/9029
All rights reserved. This handbook must not be repro-
duced in any form, even in excerpts, or duplicated or
processed using electronic, mechanical or chemical
procedures without written permission of the publisher.
This handbook may contain mistakes and printing
errors. The information in this handbook is regularly
checked and corrections made in the next issue. We
accept no liability for technical mistakes or printing
errors, or their consequences.
All trademarks and patents are acknowledged.
GB
P.22
GB
P.23
GB
P.24
GB
P.25
GB
P.26
GB
P.27
GB
P.28
GB
P.29
2. Replace batteries
Problem: No outdoor temperature is displayed.
Solution:
1. Remove all batteries, reinsert into sensor first, then
into the wireless weather station.
2. Place remote temperature sensor closer to wire-
less weather station.
3. Be sure all batteries are fresh.
4. Place remoter temperature sensor and wireless
weather station in position so the straight-line sig-
nal is not passing through more than 2 or 3 walls.
Problem:
Temperatures do not match if units are placed next to
each other.
Solution:
Each remote temperature sensor is manufactured to
be accurate to within 1 degree plus or minus and un-
der normal conditions, so two sensors could be as much
as 2 degrees different. However, the difference can be
exaggerated further because the sensors are designed
