INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
23
ArtNo.010-0009 Pushing the cooker
Fig.6-8
Installing the Flue Grille
The flue grille is packed separately
(Fig.6-9)
.
The larger of the holes along the sides are for screwdriver
access and should face to the rear. Use the screws and nuts
supplied to hold the grille in place
(Fig.6-10)
.
Clip the flexible extensions of the oven flues to the flue grille
using the clips provided inside the flue grille
(Fig.6-11)
.
Leveling
It is recommended that you use a spirit level on a shelf in one
of the ovens to check for level.
Place the cooker in its intended position, taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The rollers can be adjusted to level the cooker. To adjust the
height of the rear of the cooker, use the leveling tool supplied
to turn the adjusting nuts at the front bottom corners of the
cooker.
The front feet and rear rollers can be adjusted to level the
cooker. To adjust the height of the rear of the cooker use the
leveling tool supplied to turn the adjusting nuts at the front
bottom corners of the cooker. To set the front feet turn the
bases to raise or lower.
Leave the leveling tool in the storage drawer, so that the
customer can use it if they wish to move the cooker.
Anti-Tip Device
WARNING: The range must be secured by the Anti-Tip
bracket supplied. Unless properly installed, the range
could be tipped by leaning on the door. Injury might
result from spilled hot liquids or from the range itself.
Note:
The range must be set to the correct height and leveled
before the anti-tip bracket is installed.
Kit Contents:
1.
Anti-Tip bracket base
1
2.
Anti-Tip bracket extension
1
3.
M5 screw
2
Assemble the Anti-Tip bracket base and Anti-Tip bracket
extension as shown using M5 screws
(Fig.6-12)
.
Dimension ‘A’ should be set to give a clearance of about ¼”
(0.6 cm) above the rear channel of the range base
(Fig.6-13)
.
The assembled bracket should be firmly secured to the
floor to give a minimum engagement of 2’’ (5 cm) in the
rear channel of the range base. If the range is mounted on a
protective sheet make sure the bracket base is firmly attached
to the floor not just the sheet
(Fig.6-14)
.
ArtNo.280-0029 - Flue Grill
Fig.6-9
ArtNo.280-0030 - Fixing Flue Grill
ArtNo.280-0031 - Flue Extension Fixing
ArtNo.280-0032 - Assembling the Anti-tip bracket
2
1
3
3
A
ArtNo.011-0020 - Positioning anti-tip bracket
Range in normal
working position
A
Floor
Fig.6-11
ArtNo.280-0033 - Anti-Tip fixed to floor
Fig.6-14
Fig.6-12
Fig.6-13
Fig.6-10
