Manuale d’istruzione Sez.7 All. 9 Rev. 3 del 25.07.2013
28
supply circuit of the pellets. If the stove has not done a proper start, the following one
will use reduced quantities of pellets than that according to the setting of the auger
power adjustable from 1 to 5 (parameter code 25). If the switching is still performed
during cooling process,
the stove
goes into
standby mode
until the flue gas
temperature drops below the temperature of the stove off (parameter code 36).
make sure
to load the
pellet tank
of
fuel as
the
outside it
falling on the
suction
chamber
of the fumes can
cause a fire
in the stove
Turning off the stove
To turn off the stove press STOP button when LCD display is illuminated. The
controlled cooling system will take the stove into OFF mode.
Error system reset
The stove reports any anomalous situation through error codes and comments. Before
using the heater again, each error must be reset by pressing STOP button for about 3
seconds and until the error message on the LCD disappears.
Heating mode
It is possible to change the heating mode any time by controlling both the program and
the temperature set by the keys and following the directions of display and panel itself.
The oven automatically adjusts the power according to the program and to the room
temperature measured by the specific probe.
Saving pellet mode
If during heating the temperature exceeds the set value, the pellet stove goes into
saving pellet mode, by cooling itself. The heater will restart automatically if the
temperature falls below the set temperature for at least 1 minute.
Automatic or Manual mode
The operation of the stove can be manual: being powered on and off by the user, or
automatic: through the embedded weekly programmer or timer to automatically turn
on/off the heater at scheduled times according to your needs. To change the mode,
press the MOD key panel. The display will indicate the selected mode anytime.
Manual
The stove is controlled only manually and every ignition/shutdown is accomplished via
ON/OFF keys.
Auto
Besides being manually powered on or off, the stove checks the settings in the timer
and the weekly programme, by turning on/off at days and times preset.
Summary of Contents for GIANGI CC
