Manuale d’istruzione Sez.7 All. 9 Rev. 3 del 25.07.2013
27
HOW TO START AN AIR/WATER STOVE (Due Pi OS)
1)
KEY SET: it enters menu and confirms data changes while setting.
2)
KEY AUTO: it shifts stove’s burning from automatic to manual.
3)
KEY ON/OFF: it switches ON/OFF the stove. It resets alarm if pushed for a
few seconds, in case of error. It is even used to exit from MENU with no data
changes.
4)
TEMP+: it is used to increase the desired temperature and to scroll menu
and data.
5)
TEMP-: it is used to decrease the desired temperature and to scroll menu
and data.
6)
PROG+: It is used to increase programme or the desired working power. It is
even used to scroll menu and data.
7)
PROG-: +: It is used to decrease programme or the desired working power. It
is even used to scroll menu and data.
The board controls the working parameters of the stove automatically. The user is able
to manually control the heater, to switch it on/off or to use advanced features such as
weekly programmer and timer.
First ignition
Once powered the card, it is displayed on the LCD, the version of the resident
software and the situation of the stove that, while on ignition mode, will be shut off.
Temperature setting
The desired room temperature is set through keys Temp+ and Temp- on display
panel. Selectable values are from 15° to 30°C.
Operating programme setting
The operating programme is the heating power of the stove. This is selectable through
keys PROG+ and PROG- and goes from 1, minimum, to 5, maximum power.
Turning on the stove
To turn on the stove, press the START button for a few seconds. The stove will
automatically switch on and will set into heating phase. If it is the first ignition, and the
first load of pellets, you will need to run multiple ignitions so that pellets can enter the
circuit power. Even in the case of re-ignition, following to automatic shutdown for
finished pellet, (error code 5) an error can occur due to the depletion of the power
Summary of Contents for GIANGI CC
