L3 Aviation Products Lynx NGT-9000, Pilot'S Manual

Page: 73 / 96

Lynx
®
NGT-9000
Pilot’s Guide 3-5
Controls and Indicators
Figure 3-1: Example of CP-2500
Large Knob
Small Knob
Display
Push
Buttons
Small Knob
Button
Squawk
Code
Operational
Mode
I V M
ALT 1 2 0 0
CP-2500 CONTROL PANEL
The CP-2500 is the authorized Control Panel for the remote mount
version of the Lynx NGT-9000R. The operational information provided
in this section is limited. Refer to the CP-2500 Pilot’s Guide (0040-
17250-01) for specific details.
Note
The Flight ID function is optional and is available on the
CP-2500 if the Flight ID is configured via the DCM settings
during installation of the Lynx NGT-9000.
Press the small knob button to apply power to the control panel.
To remove power to the CP-2500, press and hold the small knob
button until the message “Power Down” is shown on the display.
(Note - This does not remove power to the Lynx NGT-9000R.)
After power is applied, if the self test passes, the CP-2500 briefly
displays “OK”. That is followed by the scrolling of the firmware
and hardware levels of the CP-2500 (approximately 15 seconds).
The CP-2500 then reverts to normal operation.
The display of the CP-2500 shows the operational mode on the
left side of the display and the squawk code on the right side of
the display as shown in Figure 3-1.
1.
2.
3.