L-Mark LK-360, User Manual

Page: 47 / 62

Label & Mark Industries Company User’s Manual of LK-360
- 45 -
4.2.20 Cut depth
The initial setting value for half-cut depth is “0”.

If you have selected the tube after press [half-cut depth] and the
screen will display as follows:

Adjust half-cut depth of tube
Select Cut depth of tube and press [Enter], then the screen will display as
follows:
Use [→] or [← ]to make your selection and press [Enter] to finish sleeve tube
semi-cutting depth. Cutting depth ascends from -3 to +3.
If you have chosen a semi-depth of +3 but are not satisfactory with the
semi-cutting results, then you may need to replace your cutter assembly.

Adjust full-cut depth
Select Full-cut depth and press [Enter] to finish your full cutting depth setting.
The cutting depth ascends from -3 to +3.
Cut depth of tube
Full-cut depth
half-cut depth of tube:
-3 -2 -1 0 1 2 3