L-Mark LK-360, User Manual

Page: 18 / 62

Label & Mark Industries Company User’s Manual of LK-360
- 16 -
4.Place the Ribbon in the ribbon holder, as shown in the picture. You will hear a
“crack” sound when it is properly located in its position.
5.Close the protective cover
Removal of printing material cassette
1.Open the protective cover
★
Make sure the print head is not pressed on the print rubber roll, in other words
make sure the print head is released;
[Attention]
If the print head is found pressed upon the rubber roll, please close the protective
cover and switch off the power and then switch on the printer about 3 seconds later.
In this way, the printer will initialize anew and the print head will return to a
proper place.
2.Raise the Ribbon and take it off carefully.
3.Remove the ribbon cassette when the catches on both sides are fully released.
4.Close the protective cover.
2.3.3 Installation of sleeve tube
1.Open the protective cover.
2. Feeding the sleeve tube under the platen of feeder until its front touch the print
rubber roll
.