Calefactore de tubo radiante Oval U-100
Manual del propietario •
Calefactore de tubo radiante Oval U-100
19
Para probar el interruptor:
• Desconecte el cableado del interruptor de presión
en los terminales PSI y PSO del control de encen-
dido.
• Dirija los cables de modo que estén en el exterior
de la caja de quemadores cuando la puerta de la
caja esté cerrada y con pestillo.
• Encienda el calefactor. Tan pronto el motor del
ventilador se ponga en marcha, conecte ambos
conectores del interruptor de aire juntos.
• Si el calefactor se enciende y funciona con normali-
dad, compruebe lo siguiente:
o Los terminales del cableado del interruptor de
presión en el control de encendido están tensos
y en buen estado.
o No hay obstrucciones en la entrada de aire
VERDE
AZUL
Válvula de control de gas
1. Quite la manguera de la trampa de sedimentos.
2. Quite las dos (2) tuercas que fijan la ménsula de mon
-
taje de la válvula de control de gas al divisor central de
la caja del quemador. Ver Fig. 18.
FIG. 18
3. Quite los cuatro (4) tornillos de la puerta de la válvula
de control. Ver Fig. 19.
4. Deslice el conjunto de válvula por la abertura de la
puerta de la válvula de gas. Ver Fig. 19.
PUERTA DE LA
VÁLVULA DE GAS
FIG. 19
Transformador
El transformador (Fig. 20) reduce el voltaje de la red de electri
-
cidad a 24 VCA. Los 24 VCA se envían directamente al contro-
lador de encendido. Una vez que el controlador de encendido
recibe los 24 VCA, empieza un ciclo de encendido.
Si el transformador está recibiendo voltaje de la red de
electricidad (115 VCA), pero en sus terminales de salida no
hay 24 VCA, significa que el transformador está defectuoso. El
calentador no funcionará, ni tampoco se encenderá la luz LED
verde que está del lado de la caja del quemador.
FIG. 20
Control de encendido
El control envía y recibe voltajes para operar los componentes
o verificar su operación. Consulte la siguiente información y la
Fig. 21 para comprender las designaciones de los terminales
del control de encendido si realiza verificaciones de voltaje en
el control.
L1:
Tensión de línea hacia el control desde la fuente de
suministro.
IND:
Tensión de línea desde el control hasta el motor del
ventilador.
LED:
Conexión para el arnés de cableado de luces de diag-
nóstico del control.
MV:
24 V de CA desde el control hasta la válvula de control
de gas.