Manual I-40 y encendido de chispa
Manual del usuario • I-40
11
DISTRIBUCIÓN DE LA INSTALACIÓN
PARA SEPARACIONES SEGURAS
3 ft COMO MÍNIMO DE DISTANCIA ENTRE
LA PARTE SUPERIOR DE LA INCUBADORA
Y EL TECHO
COLOQUE LA MANGUERA DE GAS Y EL CABLE DE ALIMENTACIÓN
ELÉCTRICA (SI CORRESPONDE) FUERA DE LA ZONA CALIENTE,
DIRECTAMENTE ENCIMA DEL CALEFACTOR. COLOQUE
LA MANGUERA DE GAS Y EL CABLE DE ALIMENTACIÓN DE FORMA
TAL QUE SE EVITE CUALQUIER POSIBILIDAD DE QUE ENTREN EN
CONTACTO CON LA SUPERFICIE CALIENTE DE LA CAMPANA DEL
CALEFACTOR.
MÍNIMO DE 3 ft DE SEPARACIÓN
DE MATERIALES
COMBUSTIBLES
PISO
I17-3,5 ft COMO MÍNIMO
I40-4,5 ft COMO MÍNIMO
DESDE LA PUNTA DEL CONO
DE COMBUSTIÓN HASTA EL SUELO
CUELGUE EL CALEFACTOR CON EL
EXTREMO DE CONTROL DE 1 A 5 GRADOS
HACIA ABAJO CON RESPECTO A LA LINEA
HORIZONTAL (VER ABAJO)
PANEL DE CONTROL
TUBERÍA DE GAS
ATENCIÓN:
■
Calefactores radiantes para edi
fi
cios agricolas de alta presion
utilizan un soporte colgante integral con enlace rápido para
colgar el calefactor.
■
Sujete solamente un cable o una cadena de acero al enlace
rápido. No utilice materiales combustibles, como cuerdas,
hilos, etc. para colgar el calefactor.
■
El instalador debe asegurarse de colgar el calefactor de
tal manera que el extremo de este quede ubicado de 1º
a 5º hacia abajo de la línea horizontal después de haber
instalado la manguera de suministro de gas. Esto per-
mite una ventilación adecuada del calefactor y elimina
daños potenciales por calor al
fi
ltro de polvo opcional.
■
Puede ser necesario reubicar el enlace rápido instalado en la
fábrica en el soporte.
■
Consulte las siguientes ilustraciones.
Distribución de la instalación
FIG. 2
CORRECTO
INCORRECTO
EL EDTREMO DE CONTROL DEBE ESTAR ENTRE
1 Y 5° HACIA ABAJO TOMANDO COMO REFERENCIA
LA LÍNEA HORIZONTAL
ENLACE RAPIDO
CABLE O CADENA
DE ACERO
SOPORTE COLGANTE
EXTREMO DE CONTROL
DEL CALEFACTOR