L-Acoustics K1, Rigging Procedures

Page: 30 / 72

K1 K1 K1 K1
reference wst
reference wst reference wst
reference wst
® ® ® ®
system
system system
system
RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES
VERSION 2.0
K1_RM_EN_2-0
w w w . l - a c o u s t i c s . c o m
28 28 28 28
18. Raise the array until the K1-CHARIOT wheels reach 0.3 m/1 ft eight.
19. Remove the K1-CHARIOT from TOWER#2 by repeating step 10.
20. For arrays of more than 8 enclosures repeat steps 11 to 19 until all TOWERS composing the array are flown.
21. If a KARA downfill array is intended to be rigged, attach it under the bottom K1 [6.4.2].
22. Fly the array at desired trim height and adjust the site and azimuth angles [9.4-9.5].
23.
Secure the K1-BUMP to the main rigging structure using two safety slings (not provided) [9.2].
6.2.3 Array removal
All along the disassembling procedure:
•
Strictly follow the sequence of the successive steps.
•
Ensure that each BLP is fully inserted by pulling on it.
For clarity purposes the loudspeaker cable removing procedure will not be described.
The loudspeaker cables will not be represented on the figures.
1. Detach both safety slings from the K1-BUMP [9.2].
2. If a KARA downfill array has been rigged, remove it from the bottom K1 [6.4.3].
3. Lower the array at 0.3 m/1 ft height.
4. Attach a K1-CHARIOT to the bottom enclosure as described below:
a. Align both rear rigging points between the K1-CHARIOT and the bottom enclosure.
b. Attach both rear rigging points (use two R-BLP).
c. Hold the K1-CHARIOT and attach both front rigging points (use two R-BLP).
Figure 23: Attaching K1-CHARIOT
IMPORTANT
WARNING
c.
L
a.
L
b.
L
b.
L