L-Acoustics K1, Rigging Procedures

Page: 26 / 72

K1 K1 K1 K1
reference wst
reference wst reference wst
reference wst
® ® ® ®
system
system system
system
RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES
VERSION 2.0
K1_RM_EN_2-0
w w w . l - a c o u s t i c s . c o m
24 24 24 24
9. Raise the TOWER#1 until the K1-CHARIOT wheels reach 0.3 m/1 ft eight.
Note: As the array is raised all angle latches should subsequently take their locking position and a “shlack” noise
should be heard.
ALWAYS check that all inter-enclosure angles have reached their locked position by making sure
that
NO yellow stickers located on the angle locking latches are visible ( except on the bottom
enclosure ).
10. Remove the K1-CHARIOT from TOWER#1 as described below:
a. Remove both front R-BLP from the bottom enclosure while holding the K1-CHARIOT.
b. Remove both back R-BLP and remove the K1-CHARIOT.
c. Place the four R-BLP back into their storage locations on the bottom enclosure.
Figure 19: Removing the K1-CHARIOT
WARNING
b.
L
a.
L
c.
L
c.
L