― 19 ―
(8) Check/change the current set value on CH2 and CH3 as well.
(9) Then, present status of one-time system is displayed. In case of
change, follow the procedure described in clause 9-2.Change of
set value.
One-time system can be selected either:
On : Recording will stop when memory is full.
Off : Overwrite the old data,and store the latest data
(10)By pressing "RANGE/▼"button, setting 1 is complete and "End"
message is displayed. Can back to "SEt.1" at first setting by
pressing "MENU/ENTER" or "START/STOP, CANCEL" button.
(11)Can back to initial measurement mode by pressing
"START/STOP, CANCEL" button.
Step3 : Clamp sensor connection, Preparation for measurement
(12)Connect the instrument and clamp sensor without clamping on
anything. Pay attention to the direction of connector and firmly
connected to the instrument.
(13)Clamp the measured object on clamp sensor.
(14)Every time when pressing "CH/▲"button, display of measured
value on CH1 to 3 can be switched. Confirm that a sensor is
connected to the instrument. When a sensor is not connected,
"nc"(non-connect) is displayed on the LCD.
(The measured value will not be recorded when sensor is not
connected at starting to record.)
