KYMCO Venox 250, Service Manual

Page: 88 / 243

6
. CYLINDER HEAD/VALVES
6-10
VENOX250/250i
VALVE /VALVE GUIDE
Inspect each valve for bending, burning,
scratches or abnormal stem wear.
Check valve movement in the guide.
Measure each valve stem O.D.
Service Limits :
IN 4.90mm replace if below
EX 4.90mm replace if below
Measure each valve guide I.D.
Service Limits : IN: 5.05mm replace if over
EX: 5.05mm replace if over
Subtract each valve stem O.D. from the
corresponding guide I.D. to obtain the
stem-to-guide clearance.
Service Limits : IN: 0.175mm
EX: 0.155mm
CYLINDER HEAD ASSEMBLY
Lubricate each valve stem with engine oil
and insert the valves into the valve guides.
Apply engine oil to the valve stem seals and
install them into the valve guides.
Install the valve spring seats, washers, inner
and outer springs, and retainers.
Compress the valve springs using the valve
spring compressor, then install the valve
cotters.
Valve Spring Compressor
Valve Guide
＊
x
If the stem-to-guide clearance exceeds
the service limits, replace the guides.
x
Reface the valve seats whenever the
valve guides are replaced.
Valve
Be sure to install new valve stem seals.
＊
Seal
Valve Spring Seat
Spring
Retainer
Cotter
Valve Spring Compressor
＊
x
Use the valve spring compressor to
compress the springs and do not
damage the cylinder head surface.
x
Install the cotters with the pointed ends
facing down.
Special