12
CONTROLS & FEATURES
Headlight switch
1
1
1
1
1
"
" position:
The headlight and taillight will be lit.
"
" position:
The position light and taillight (running lamps) will be lit.
"
" position:
The headlight and taillight will be off.
NOTE: Not all Quannon motorcycles have switches that
control the headlight circuit. Depending upon country and
state regulations, your motorcycle's controls may differ
from the switches described here.
NOTE: The starter motor will not engage unless the front
brake lever is squeezed or the rear brake lever is depressed
at the same time the starter button is pressed.
Release the starter button immediately after the engine
has started.
To prevent damage to the starter motor, do not operate
the starter motor for more than five seconds at a time.
If the motorcycle fails to start immediately, check the fuel
level and the battery condition. Allow the starter motor to
cool before attempting to start the engine again.
Engine stop switch
3
3
3
3
3
"
" position:
The ignition circuit is off. The engine will not start or run.
Electric starter button
2
2
2
2
2
"
":
Turn the ignition switch “ON” and press the electric starter but-
ton to activate the starter motor.
Right handlebar switch
1
1
1
1
1
2
2
2
2
2
3
3
3
3
3
4
4
4
4
4
Engine stop switch
4
4
4
4
4
"
" position
The ignition circuit is on, and the engine can start and run.
