KYMCO G-Dink 125i, Manual

Page: 401 / 451

11. Electrical System > Self-Diagnosis G-Dink 125i
31
Spark Plug Anti-Flood
When no failure code occurs and pressing starter switch repeatedly can
still not start the engine the spark plug maybe fouled be a flooded
engine. Perform the spark plug anti-flood to purge the fuel in the engine.
Make sure the battery voltage is greater than 12 V.
1. Close the throttle, turn the ignition switch to ON.
2. Open and hold the throttle fully, pressing starter switch more than 3
seconds.
TPI/ABV Reset
●
After replacing throttle body or engine overhauled, It will change the
efficiency of air intake so must be do the TPI/ABV initialization process.
●
If the throttle cable is being moved when the throttle body is installed
it can cause a hard to start engine or incorrect idling speed.
●
ABV controls air bypass valve to obtain a smooth idling speed. The
ECU may record the incorrect ABV position when the ECU or the
throttle body has been reinstalled. It can cause engine stop, hard
to start engine or rough idling speed.
The throttle position sensor (TPS) and air bypass valve (ABV) have
to be reset when throttle body or ECU have been reinstalled.
TPI/ABV RESET PROCEDURE
●
When the vehicle is started, turn off the ignition and Key On again
at engine stop working. Use the testing rod or wire clip short Reset
(Pink color) wire to touch the negative wire or the body frame to
complete TPI/ABV resetting procedure.