KYMCO G-Dink 125i, Manual

Page: 296 / 451

7. Steering > Handlebar G-Dink 125
i
17
Grips
If you plan to replace the grips you can slice them lengthwise with a
razor blade and peel them off. To remove the grips without cutting them
use a screwdriver to open a gap between the grip and the handlebar.
Spray in contact cleaner to break up the grip cement. Use compressed
air to expand the grip so it can be easily slid off the end of the
handlebar. Note the relationship between the angle of the grip and the
throttle tube so that the new grip can be installed with the correct angle.
NOTE: Always wear safety glasses when using compressed air and
never point it directly at yourself or anyone else.
Before installing the grips to either the throttle tube or the handlebar,
wipe down the area with a brake or parts cleaner that will dry without
leaving a residue. When you are sure the area is dry apply grip cement
to the bar or tube. Install the left grip at an angle of your preference.
Install the throttle grip onto the tube with the same angle as the original
grip.
Installation
Handlebar