KYMCO Downtown 200i, Service Manual, Page: 107 / 230

10. A.C. GENERATOR/STARTER CLUTCH
10-8
DOWNTOWN 200i
Install the starter idle gear and shaft.
Install the starter driven gear onto the
crankshaft.
FLYWHEEL INSTALLATION
Install the flywheel onto the crankshaft by
aligning the key on the crankshaft with the
groove in the flywheel.
Install washer and nut.
Hold the flywheel with the flywheel holder and
tighten the flywheel nut.
Torque : 5.5~6.5 kgf-m (58.8 N-m)
Remove the flywheel nut and washer.
Flywheel holder E021
Flywheel
Key
•
Before installation, check and make sure
that the inside of the flywheel is not
contaminated.
＊
Special
Shaft
Starter Driven Gear
Starter Idle Gear
Flywheel
Nut
Flywheel Holder