KYMCO Dink 50, Service Manual

Page: 5 / 424

1. GENERAL INFORMATION
1-4
DINK 50/125
SERVICE PRECAUTIONS
„
Make sure to install new gaskets, O-rings,
circlips, cotter pins, etc. when
reassembling.
„
When tightening bolts or nuts, begin with
larger-diameter to smaller ones at several
times, and tighten to the specified torque
diagonally.
„
Use genuine parts and lubricants.
„
When servicing the motorcycle, be sure to
use special tools for removal and
installation.
„
After disassembly, clean removed parts.
Lubricate sliding surfaces with engine oil
before reassembly.
„
Apply or add designated greases and
lubricants to the specified lubrication
points.
„
After reassembly, check all parts for proper
tightening and operation.
„
When two persons work together, pay
attention to the mutual working safety.
„
Disconnect the battery negative (-) terminal
before operation.
„
When using a spanner or other tools, make
sure not to damage the motorcycle surface.
„
After operation, check all connecting
points, fasteners, and lines for proper
connection and installation.
„
When connecting the battery, the positive
(+) terminal must be connected first.
„
After connection, apply grease to the
battery terminals.
„
Terminal caps shall be installed securely.