Mounting
10
connecting seat is detached from the DIN rail. In this way, the device is removed
from the DIN rail completely.
Figure 7 DIN-Rail Dismounting
3.2.2 Panel Mounting
Caution:
To adopt panel mounting, you need to purchase the plate for panel mounting (optional).
Mounting
Step 1: Use screws to fix the plate for panel mounting to the rear panel of the device.
Step 2: Select the mounting position (on a wall or inner wall of a cabinet) for the device and
guarantee
adequate
space
and
heat
dissipation
for
it
(dimensions:
53.6mm×135mm×106.5mm).
Step 3: Punch four holes in the selected position according to the dimensions for panel
mounting. Insert four screws into the four holes respectively, and turn the screws
with a screwdriver until about a 5mm distance is left between each screw head and
the wall.
Step 4: Align the four mounting holes on the plate for panel mounting with the four screws.
Make the screws pass through the Ф6.5 positions in the following figure. Move the
device in direction 1 until the four screws are in the Ф4 positions. Then tighten the
screws to complete mounting.
