Step 1:
Assign the PC or laptop IP address through Windows >
Control Panel > Network Connections > Local Area
Connections > Status > Properties > Internet Protocol
(TCP/IP), Use the following IP address. Type the IP
address field with 192.168.168.11 and Subnet mask
with 255.255.255.0. After that press OK to save the
configuration. (See the following picture)
Step 2:
Hold the
Reset
button of the device and power on. The
power LED of the device will blink red. The power LED
will become orange and the status LED in red. Only in
this status, you can get access to the HTTP server of the
device. On the other word, you cannot get access to the
HTTP server in other status.
Step 3:
Use an Ethernet Cable to connect the PC or laptop
and the device. The power LED is still orange and the
status LED becomes green blink.
Step 4:
Ping the connected device through the sequence, Start,
Run, cmd, ping 192.168.168.21 or ping 192.168.168.22.
You will receive the reply if the connection is
established. Use IE browser to get access the web
server. You can setup IP address, subnet mask,
gateway, device name, network protocol and
destination in this page.
Kvm groupe
http://www.kvmshop.dk
20
Summary of Contents for DSIP-1000
