Option 2 - Route the Cable Behind the Hatch
1.
Move the steel fitting down the length of the
antenna cable to the end opposite the rubber
boot. You’ll need to connect the end of the cable
with the rubber boot to the antenna.
You will not
need to use the fitting; simply keep it attached to the
end of the cable inside the vehicle.
2.
Starting from inside the vehicle, pass the antenna
cable through the gap in the hatch hinge.
3.
Connect the antenna cable to the antenna. Hand-
tighten, then tighten with a
7
⁄
16
" wrench for
1
⁄
4
turn
to ensure an electrical and weatherproof
connection.
4.
Slide the rubber sealing boot up the cable until it
covers the antenna cable connector. This boot will
help protect the connector from the elements.
5.
Using the supplied tie-wraps
(or equivalent)
,
secure the cable to the roof rack, if necessary.
54-0350
2.20
TracVision A7 Installation Guide
Cable Routed Behind Rear Hatch
Antenna Cable
Hatch
Do not kink the cable. Maintain a bend
radius of at least three inches. A tighter
bend may disrupt the TV signal and
degrade performance.
Connecting the Antenna Cable to the Antenna
Rubber Boot
