Adjustments
74
Lighting kit for folding
machine
•
Working position: The signaling arm is adjusted in the upper
position.
•
Transport position: The signaling arm is adjusted in the lower
position.
Front cutting discs
(FCD)
The communication valves located in the jack chambers are only open
when the jacks are deployed.
Adjusting the pressure on the discs
Adjust the pressure on the discs using the jacks.
Compensation for disc wear
It is possible to retain an optimal working range despite disc wear:
Remove screws A and B located on each attachment.
Place the screws in B and C.
Tighten the screws (refer to the tightening torque section for
standard screws).
Folding machines: synchronize the jacks
The jacks are mounted in series, so it is necessary to drain the
system:
Activate the command to completely deploy the jacks.
Once the jacks are deployed, continue to operate the control for a
few moments to fill them completely,
Front mixer discs (FMD)
•
One straight disc 450 mm (
18”
) in diameter in the center.
•
450 mm (
18”
) curved discs every 300 to 320 mm (
12
to
12
1/2
)
intended to mix and incorporate straw debris into the earth.
•
Non-stop release safety system.
\
IMPORTANT
Do not fold the machine if the lights are in the working
position.
This could cause serious damage to the machine.
A
B
C
A
B
C
Reference
Designation
A
Front Mixing disk FMD
B
Front cutting disk FCD
C
Push bar
Summary of Contents for CLC PRO
Page 8: ...Safety 8 ...
Page 9: ...Safety 9 Folding machines ...
Page 10: ...Safety 10 ...
