Adjustments
72
Passive knife skids
Introduction
Use this configuration if:
•
You want a coarser level and surface finish in order to avoid any
risk of surface breakdown.
•
You are working in the autumn and you want to sow in the spring.
•
You are not planning to sow for a long time.
Adjustment procedure
on Actiring and Actipack
Raise the knife skids fully to put them in the OFF position (folded
away).
Loosen the locknut.
Loosen the countersunk screw (A) with the small spanner (B) so
that it protrudes by about 1 cm from its conical housing.
Loosen the locknut on the other side.
Engage the long spanner (C) on the welded nut located on the
lower part, such that the rear rail is supported.
While holding the spanner (C) in position, loosen the countersunk
screw (A) with the small spanner (B) so that it protrudes by about
1 cm from its conical housing.
Swing the rail to the required position (1, 2, 3 or OFF).
Still holding the spanner (B) in position, fully tighten the
countersunk head screw (A).
Tighten the locknut.
Go to the other side to fully tighten the other countersunk head
screw (A). If necessary, use spanner (C) again to adjust the
alignment of the screw to the desired position.
Tighten the second locknut.
Scrapers on Actipack
If using scrapers on the roller:
Set the scrapers to OFF position.
The scraper must not touch the central tube, in respecting a
clearance of 5 (
3/16”
) to 10 (
6/16”
) mm relative to the tube.
\
DANGER
No one should stand close to the tractor’s controls while the rollers
are being adjusted.
A
B
C
Summary of Contents for CLC PRO
Page 8: ...Safety 8 ...
Page 9: ...Safety 9 Folding machines ...
Page 10: ...Safety 10 ...
