33
WEEKLY
1. Check machine for worn, damage or missing parts. Replace with genuine Kverneland Parts.
2. Check parking brake effectiveness (where fitted). Adjust if necessary.
3. Check that wheel nuts are tightened to the correct torque:
Kverneland 608 / 610, 70 mm square axle - 300 Nm.
Kverneland 612 / 614, 80 mm square axle - 420 Nm.
Kverneland 616 / 618, 90 mm square axle - 420 Nm.
4. Check tyres are inflated to correct pressure:
12.5 / 80 x 15.75:
6 BAR
(315 / 80) x R 22.5 tyres: 7,9 BAR
40 x 14 tyres:
4 BAR
385 / 65 x R22,5 tyres:
6 BAR
5. Check transmission oil level.
6. Check primary and main transmission chain tensions - adjust if necessary.
7. Check conveyor of the tape tensions - adjust if necessary
MONTHLY MAINTENANCE
1. Check and ensure axle clamping plates are secure, check bolts re-torque to 110 Nm.
2. Check drawbar bolts and re-torque to 840 Nm.
3. Check M30 hitch bolt an re-torque to 1400 Nm.
4. Check Load Cell securing bolts and re-torque to 420 Nm.
3.
Check that all safety decals are clearly legible; replace if necessary.
5. Check auger sprocket retaining plate bolts and re-torque 420 Nm.
6. Carry out lubrication checks as detailed in the lubrication chart.
7. Dismantle sliding sections of PTO shafts. Clean and re-grease using Shell Calithia EPT2 grease or
equivalent. Lubricate PTO guard bearing collars.
PTO SHAFT
The PTO shaft guards MUST be maintained in good order at all times and replaced immediately when worn or
damaged. Ensure that the PTO shaft is safely secured to the support bracket, or remove the shaft from the
machine and store separately to prevent damage and deterioration when the machine is not in use.
HYDRAULIC HOSES
IMPORTANT!
The condition of all hoses should be carefully checked during routine service of the machine.
Damage to brake lines must be corrected before any use.
AIR BRAKES (WHERE FITTED)
The pressure within the air reservoir should be released occasionally to reduce the risk of condensation; which
could lead to corrosion and damage to the braking mechanism. It is recommended that braking systems are
checked by your Kverneland dealer at least once per year.
IMPORTANT!
If any component requires repeated adjustment and/or maintenance, you MUST consult your
Kverneland dealer.
