35
SECTION 7 - ANNUAL MAINTENANCE AND STORAGE
At the end of the season’s use and prior to storing the machine, proceed as follows:
SAFETY FIRST!
Tractor handbrake must be applied, machine brakes applied (or wheels
chocked), tractor engine must be switched off and key removed. The PTO
shaft MUST be removed before attempting this operation.
1.
Remove the front drain plugs and thoroughly wash all material and dirt from the machine.
2.
Carry out all lubrication checks. Grease all adjuster screws and exposed ram pistons.
3.
Clean PTO shaft, re-grease and store in dry conditions to prevent damage and deterioration.
5.
It is recommended that the machine is placed under cover or protected by a tarpaulin or canvas sheet. DO
NOT use plastic sheeting, as this can cause rapid corrosion.
IMPORTANT!
If the machine is to be stored outside, position it so that any rain and moisture will drain towards
the front, where the drain plugs are located. Ensure that the drains plug are open at all times
when the machine is not in use.
6. Where possible, relieve hydraulic pressure that may be stored in hoses and rams.
SAFETY FIRST!
If the machine is fitted with the hydraulic jack, DO NOT release the
pressure in the cylinder unless the drawbar is securely supported on firm,
level ground
For extended periods of inactivity, it is recommended that the machine is parked on firm
level ground; chock the wheels and place the drawbar/chassis on adequate supports - do
not rely upon the brakes or chassis jack.
SECTION 8 - PRE-SEASON CHECKS
1.
Remove protective grease from ALL ram pistons.
2.
Carry out all maintenance and lubrication instructions as detailed in Section 4.
3.
Check that ALL guards and warning decals are in place. Replace any that are damaged or missing.
4.
Ensure drain plugs are re-fitted correctly
5.
Inflate tyres to correct pressures and remove supports
6. Ensure that all hydraulic (and pneumatic, if applicable) hoses are in good condition and the fittings are
intact and secure.
7.
Check the condition and level of the oil in the transmission case. Fill to the correct level if required.
8.
Re-fit the PTO shaft and connect machine to tractor as detailed in Section 1.
9.
Check operation of brakes.
NOTE!
Carry out all pre-operational checks as detailed in this manual
