Section 7--System Operation
7.6
The Eagle II automatically runs an internal test prior to
locking any speed. Depressing the TEST switch will
allow the Eagle II to complete a lamp and internal test
then return the locked speed.
9. If the remote control is damaged or lost, refer to Section
4.2.0 for default operation of the Eagle II without a
remote control.
7.3.
Moving Operation
1. Place the Eagle II in the moving mode of operation by
depressing the MODE switch and observing the
mode/antenna indicators. The patrol and an opposite
direction indicator should be lit.
MODE
Select
Moving
SAME
OPP
Select
Opposite
or
FRNT
REAR
Select
Antenna
2. Select the desired antenna, front or rear (if equipped
with dual antennas) by depressing the FRONT/REAR
switch on the remote control. Set the fan interference
filter to the desired state (see Sec 7.1).
3. Set the minimum patrol speed to the desired level--10 or
20 MPH (16 or 32 km/h). To activate this feature once
the unit has been placed in Moving Mode, press the
remote’s PAT/SEL switch once. The TARGET window
will display “PAt” and either 10 or 20 will appear in the
PATROL window. This display will be active for two
(2) seconds unless another switch is pressed. To change
the displayed minimum speed, press the MODE switch,
which will toggle between the two speeds.
