Section 6--Testing Procedures
6.6
6. Repeat steps 3, 4, and 5 using the higher speed (55
MPH, 65 MPH, 80 km/h) tuning fork. The TARGET
speed display should indicate the same speed as the
tuning fork (55, 65, or 80).
NOTE: Since the Eagle II with an antenna labeled “DCM”
can determine that tuning fork signals are not
moving targets; the speeds displayed as a result of
the fork tests cannot be LOCKED. Thus step 7
cannot be performed for antennas labeled “DCM”.
7. If the antenna label does not read “DCM” while the
TARGET display is indicating the higher speed,
momentarily depress the LOCK/REL switch. Verify
that the LOCK display is reading 55 or 65 and a short
alert tone was heard. The TARGET speed display
should still indicate 55 or 65 (80 km/h) as long as the
tuning fork is ringing. Depress the LOCK/REL switch a
second time and the locked speed should be erased.
8. Depress the MODE switch and place the Eagle II in the
moving mode, opposite direction, front antenna. Only
the patrol LED and the front, opposite direction LED
indicator will be lit. If speedometer input is used,
depress the TEST switch to temporarily remove the
synchronization, allowing tuning fork testing.
MODE
Select
Moving
or
FRNT
REAR
Select
Antenna
9. If the antenna label reads “DCM”, momentarily press
the TEST switch to enter the TEST mode. The TEST
indictor will be flashing while in the TEST state. The
radar system will remain in the TEST state for 30-
seconds. Note: pressing the TEST switch while the unit
is in TEST mode will take the unit out of TEST mode
immediately.
