9
3BA00221 • 2014-09-18 • Rev. 5
ersa i-CON2 & i-CON 2V
4.4
Contrast
Do the following to adjust the display contrast individually
based on the work environment:
■
Turn the station on and immediately turn the i-OP. This
will activate the contrast mode:
The buzzer tells you that the contrast mode is on.
■
Adjust the contrast as needed by turning the i-OP.
■
Confirm your choice by pressing the i-OP.
5.
Editing parameters
To edit the value of a parameter, do the following:
■
Press the i-OP to turn on the soldering iron that you
wish the edit the parameters on.
■
Press and hold down the i-OP for approximately 2
seconds.
■
Select the required parameter by turning the i-OP.
■
Turn the cursor on by pressing the i-OP. If you press it again the cursor
will switch off.
When the cursor is on, the value of the parameter is changed by turning the i-OP.
2
0
_
1
0
_
1
0
_
0
2 s
1
0
_
♪!
2
♪!
0
2s
0
0,5 s
3
0
_
2
0
_
Operating modes
