59
EN
Installation instructions
Before installation
Check that the input voltage
indicated on the
characteristics plate is the same as the voltage of
the power outlet you are going to use. The rating
plate is located on the front part of the cavity and it
is only visible after opening the door.
Open the oven door and
take out all the
accessories
and remove the packing material.
Do not remove the mica cover
on the ceiling of
the interior! This cover stops fat and pieces of food
damaging the microwave generator.
Warning!
The front surface of the oven may be
wrapped with a
protective film
. Before using the
oven for the first time, carefully remove this film,
starting on the inside.
Make sure that the oven is not damaged in any
way.
Check that the oven door closes correctly
and that the interior of the door and the front of the
oven opening are not damaged. If you find any
damage contact the Technical Assistance Service.
DO NOT USE THE OVEN
if the power cable or
the plug are damaged, if the oven does not
function correctly or if it has been damaged or
dropped. Contact the Technical Assistance
Service.
Put the oven on a flat and stable surface. The
oven must not be put close to any sources of heat,
radios or televisions.
During installation, make sure that the power
cable does not come into contact with any
moisture or objects with sharp edges behind
the oven. High temperatures can damage the
cable.
Warning: after the oven is installed you must
make sure you can access the plug.
After installation
The oven is equipped with a power cable and a
plug for single phase current.
If the oven is to be installed on a permanent
basis
it should be installed by a qualified
technician. In such a case, the oven should be
connected to a circuit with an all-pole circuit
breaker with a minimum separation of 3 mm
between contacts.
WARNING: THE OVEN MUST BE EARTHED.
The manufacturer and retailers do not accept
responsibility
for any damage that may be
caused to people, animals or property if these
installation instructions are not observed.
The oven only functions
when the door is closed
correctly.
After the first use, clean the inside of the oven and
the accessories, following the cleaning instructions
given in the section “Oven cleaning and
maintenance”.
Fit the Turntable support in the centre of the oven
cavity and put the Turntable ring and the Turntable
plate on top,
making sure they slot in. Whenever
you use the microwave, the turntable plate and the
respective accessories must be inside and
correctly fitted.
The turntable plate can rotate in
both directions.
During installation,
follow the instructions supplied separately.
