Kuppersberg GL4505, Technical Passport

Page: 14 / 44

14
Technical passporT english
dishwasher
2. Remove the cup fi lter B by exerting a
slight pressure on the side fl aps.
3. Slide out the stainless-steel plate fi lter C.
4. Inspect the trap and remove any food
residues. NEVER REMOVE the wash-cycle pump
protection (black detail).
After cleaning the fi lters, re-place the fi lter
assembly and fi x it in position correctly; this
is essential for maintaining the effi cient
operation of the dishwasher.
The dishwasher must not be used without
fi lters or if the fi lter is loose.
Clean the fi lters regularly.
CLEANING THE SPRAY ARMS
On occasions, food residue may become
encrusted onto the spray arms and block the
holes used to spray the water. It is therefore
recommended that you check the arms from
time to time and clean them with a small non-
metallic brush.
To remove the upper spray arm, turn the
plastic locking ring in an anticlockwise
direction. The upper spray arm should be
replaced so that the side with the greater
number of holes is facing upwards.
The lower spray arm can be removed by
pressing on the side tabs and pulling it upwards.
LEAVING THE MACHINE UNUSED FOR
EXTENDED PERIODS
Disconnect the appliance from the electricity
supply and shut off the water tap.
Leave the door of the appliance ajar.
When you return, run a program when the
dishwasher is empty.