4 - 23
Programming
4.6.17. Program transfer
Apart from the programs (0...7/31) in the memory of the cam
control unit there is also program no. 32 (for some old devices:
no. 8). This program is in the memory of the operating terminal
PG 674. In the display, it is called "BT" .
It is used for:
- program transfer from one cam control unit to another
- transfer to the place of programming (KUAX 674 and PC
running NOBES 674) for program backup and documentation
- intermediate storage of a program when copying and/or ex-
changing programs
Do not transfer programs when machine is running.
Reason: when copying between program 32 (BT) in the
operating terminal and programs 0...7/32 in the cam
control unit the program is stopped for a few seconds and
the outputs are switched off for the same period.
Press
Display
Note
copy from _
which program?
copy from 0_
program 0
copy from 0 > _
where to?
copy from 0 >32_
to the operating terminal
Copy from 0 > BT
Yes=ENT No=ESC_
are you sure?
controller STOP?
Yes=ENT No=ESC_
really?? (stop = outputs off)
Pos:312 O:0.00
P00 n:0000 rpm
after a few seconds: function
OK
Summary of Contents for PG 674
Page 6: ...Contents 4 Table of contents ...
Page 18: ...3 6 Operating terminal PG 674 ...
