- 19 -
3) MAXIPACKER ROLLER
HR 5002 DR / 5002 DR - S : Code 123 8410, quantity 2
HR 6002 DR / 6002 DR - S : Code 123 8420, quantity 2
This roller is suitable for all soil types and especially humid and sticky soils. It provides an efficient ground packing,
a good levelling and crumbling.
Due to its large diameter cylinder, it provides a large ground contact area, hence reduced sinking and less resistance
to rolling, meaning a reduced traction power is needed. The scraperbar is part of the maxipacker roller.
The scraper plates located between the rows of studs ensure the cleaning of the roller. They are hard coated to further
increase their service life.
In case of blocking with crop residues, the scraper bar can be easily pivoted to permit cleaning.
a) Fitting the maxipacker rollers and their scrapers
(photos A and B).
When fitting the rollers, be sure to check their direction of rotation (see arrow on photo A). (The direction of rotation
is also indicated by a sticker on the side of the rollers).
Fit each roller and scraper supports (D) to the 2 corresponding arms (B), using the guide housing and the 8 bolts
(U). Then fit scraper supporting bar (H) onto the 2 support arms (D) with the 6 bolts (R). Do not tighten the bolts.
Fit the 2 adjusters (Q) photo B).
Using the 2 nuts (S) on the adjusters, pivot the scraper bar towards the roller until it is almost bottomed-out in the
2 slots of the support arms (D) (photos A and B). Then tighten the 6 bolts (R) to a torque of 22 daNm / 160 ft.lbs,
and if required adjust the position of the scraper plates (P) as shown thereafter.
A
B
