- 20 -
WORKING POSITION
- Raise the machine.
- Using the box spanner (P) delivered with the machine, release the lock on the front guard (A) (photo 20).
- Using levers (K) fold the transport locks (J) towards the rear and lock them in place (photo 21).
- Pivot both side guard flaps (L) towards the outside in working position making sure to slide the tubes (T) in the
rectangular housings (E) (photo 22).
- Lock the side guard flaps (L) by lowering and locking of the front guard flap (A) (photo 21) and attach tensioners
(U) to the lower mounting yokes (I) of suspension springs (S) as shown in photo 22 A.
- Lower the machine on the ground.
- Make sure that all safety curtains are in correct position.
- Check that the lever (L) is locked in place in the forward notch (A) of the selector plate (photo 8A, page 14).
If the mower has been attached correctly, chains (G) are tight (photo 22 B), the cutterbar rests on the ground
and distance (Y) is at least 210 mm (8").
When operating with a tractor equipped with a double acting hydraulic lift, the spool valve
must be set in the detented fourth position (float position) to allow the cylinders to travel up
and down at will.
During work the tractor valve must always be shifted in the free floating position.
21
22A
22B
Summary of Contents for GMD 602 F
Page 11: ... 9 ...
