- 13 -
ADAPTING THE MOWER TO THE TRACTOR
1) ATTACHING MOWER TO TRACTOR
- Mount the two hitch pins (T) on the lower yokes
(I)
of the A frame (A) and secure them by means of the
roll pins (E) (diameter 8 x 45) (photo 6).
- Then attach the support chains (R) to the hitch pins
(T) using the bigger end link (photo 6). Secure them
with the lock plates (V) and linch pins (G) (photo 6).
- Lower the tractor front hydraulic lift and attach the
mower (photo 7).
- Connect the PTO shaft.
- Thread safety pin (S) through hole (6) of latch (4) of
triangular frame (A) (photo 7 and fig. 7 A).
Note : The safety pin (S) has a 4 mm diameter. If hole
(6) of the A-frame used is not big enough to
accomodate this pin, counter drill it to 4.5 mm.
Check that stop (3) of the triangular frame (A) is
adjusted correctly. For good operation this stop must
be positioned against latch (4) so that latch is still free
to pivot when pulling lever (5).
For adjustment, detach mower from the tractor and
proceed as follows :
- Untighten flush screw (2) so that stop (3) is free to
slide.
- Untighten lock nut of adjusting screw (1).
- Attach mower to the tractor.
- Rotate adjusting screw (1) until stop (3) contacts
latch (4).
- Check that latch (4) is free to operate by pulling lever
(5). If operation is difficult untighten screw (1) half a
turn.
- Detach machine from tractor.
- Tighten lock nut of adjusting screw (1) and tighten
flush screw (2).
Regularly check that stop (3) is adjusted correctly,
especially each time the mower is adapted to a new
A frame (A). Readjust if necessary.
6
7
Summary of Contents for GMD 602 F
Page 11: ... 9 ...
