-11-
FITTING TO THE TRACTOR
The EL 100N Power Tiller can be fitted to all tractors with a standard 3-point frame
and Cat. I or II lower link pins.
For tractors with Cat. II linkage, the lower link arms are fitted to the interior
of the attachment bracket (fig. A). For tractors with Cat. III linkage, the lower
link arms are fitted to the interior or exterior of the attachment bracket (fig. B
and C).
Cat. II Diameter 25 - 28mm Figure A L = 870 mm
(1" - 1 1/10") (34 1/4")
Cat. III Diameter 31 - 37mm Figures B and C M and N = 1010mm
(1 - 1 5/11") (39 3/4")
PTO DRIVE SHAFT
Before attaching the PTO shaft to the slip clutch flange, it is essential that both
mating surfaces are thoroughly cleaned.
Bring both components together and fix in place using the self-locking screws
provided. Tighten all the studs to a torque setting of 10 daNm at the same time making
sure that the flange is centrally seated.
AFTER THE FIRST FEW MINUTES OF OPERATION, THE FLANGE STUDS MUST BE CHECKED FOR
TIGHTNESS AND THEREAFTER CHECKED DAILY, TIGHTENING THEM WHEN NECESSARY.
Summary of Contents for EL 100 N
Page 1: ...ASSEMBLY OPERATOR S MANUAL EL 100 N POWER TILLER N 95458 A GB 12 1999...
Page 10: ...8...
Page 18: ...16...
