KUHN ATHENOR 6070, Operator'S Manual

Page: 41 / 98

Putting into service
Silo unloader - Straw spreader - Mixer - Distributor
ATHENOR 6070
39
„
Setting the coupling drawbar
Adjusting the drawbar allows you to position the body at
the desired level no matter which tractor is used.
- Adapt the height of the drawbar to the tractor used as
follows:
• 6 height settings are possible for 2 positions of the
drawbar support plate (4) et (5).
• Dismantle the drawbar by removing shaft (6).
• Loosen the 8 bolts (7) and (8) on each side of the
drawbar (24 wrench).
• Set plates (4) and (5) in the desired position.
• Reinsert the bolts (7) (8) in the holes required
(torque 29 daNm.
• Raise the drawbar.
• Reinstall shaft (6).
For a good mixture, the back of the body must be
slightly lower than the front.
To change from position (A) to position (B), or
the revers, rotate the drawbar (4) (5) support
plates by 180°. Reverse the two plates: put the
right hand plate on the left and the left hand plate
on the right.
The different coupling heights according to the
position of the drawbar support plate: position
(A) or (B) and orifices (1) (2) or (3) are given for
standard wheels.