2
1
14
15
16
17
18
19
20
21
Seal shown shorter
for clarity
Insert glazing seals
as
shown, around the
outside
of the fixed panel.
Also at this stage fit the inner fixed
patch covers as shown, you will not
be able to fit all of these once the
door glass is installed.
Remove
the wheel patch
fixings from the door glass
using the 4mm allen key
supplied. Sit these patch fittings into
TOP
rail upside down then turn the
right way around to lock them into the
rail.
Carefully feed the glass into
the unit and match up the top
holes with the wheel patches.
Screw the inner cover back on.
Ensure the shoulders of the patch
fittings are tight against the top edge
of the glass.
If the handing of the door glass is
being changed then you will need to
remove the quick release patches
and splash seal and ensure they are
to the bottom of the door with the
levers pointing towards each other.
FIT COVER CAPS,
to all
patch fittings and each wallpost
Secure wallpost cover caps
using No.4 x 10mm long screws
provided.
FIT VERTICAL DOOR
seal
onto the opposite edge of the
sliding door to the handle.
Position stop blocks to prevent the
handle of sliding door impacting on
edge of fixed panel, then tighten allen
key grub screws with 2.5mm Allen
Key.
TIP
If seals feel tight, then
wetting in clean water
will help. Ensure you do
not stretch the seals. Trim
to correct length.
Adjust
the hanging of the door
so that the closing edge of the
glass meets the closing seal
evenly over it’s entire height. Gain
access to screw “A” by removing the
top patch cover.
SLIDING DOOR
VIEW
FROM INSIDE
TOP
TO RAISE THIS
SIDE OF DOOR
USE SCREW
‘A’
TO LOWER
THIS SIDE OF
DOOR USE
SCREW ‘B’
A
B
TO RAISE THIS
SIDE OF DOOR
USE SCREW
‘A’
TO LOWER
THIS SIDE OF
DOOR USE
SCREW ‘B’
A
B
A
B
Roller bearing adjustment-
using
screwdriver, loosen screw (do not remove), re-
position in slot and re-tighten.
Patch fitting adjustment-
using allen key,
loosen screw (do not remove), lower glass and
re-tighten.
FIXED
DOOR
Silicone seal
the wallposts.
Both wallposts should be
sealed vertically to the tiled /
panelled walls on the
Outside &
Inside
of the enclosure.
Silicone seal
the enclosure
to the tray on the
outside only
You should also seal the joint
as shown.
IMPORTANT!!
Do not seal to the tray
on the inside, this will prevent drainage
of the frame work and will cause
leakage problems
Seal joint at both ends
of the bottom rail
Keep inner fixings
to hand when
positioning the
glass door
?
?
Check
the running of the
door, vasaline can be applied to
the bottom track to improve the
sliding action
Check
that the shim strip has
been installed under the bottom
rail
?
Check
that all the screws and
fittings are fully tightened
?
Ensure
that the quick release
levers are to the bottom of the
door
?
Leave
for 24hrs before use to
allow silicone sealant to cure
Bottom & Top
TIP
Support weight of
glass on your foot
when securing to the top
wheel patches
PLEASE ENSURE THAT AFTER ADJUSTMENT
ALL SCREWS ARE FULLY TIGHTENED
