4
Remove the clip in extrusion from the inside face of door frame on handle side by pressing
down along entire length as shown in
Fig. 4.1
then lifting away and out as shown in
Fig. 4.2
Remove the clip in extrusion from the inside face of door frame on fixed panel side by lifting
up along entire length as shown in
Fig. 5.1
then lifting away and out as shown in
Fig. 5.2
5
4.2
4.1
PRESS DOWN ALONG
LENGTH TO RELEASE
5.1
5.2
6
7
Trim the excess lengths off wall post bubble seals (x4) Carefully offer frame into opening and
expand door width equally on both sides by turning the nylon adjustment screws - 3 at each
side of the door - in an anti-clockwise direction. Only tighten until door is lightly wedged in
position.
Fig. 6.1
Set door level on tray by turning relevant height adjuster screw (clockwise to raise) if necessary.
Use a spirit level to ensure accurate levelling.
Fig. 7.1 and 7.2
TO RAISE
TO EXPAND
6.1
7.1
7.2
Insert wall plugs provided or fixings to suit the construction of your walls
(below tiles to avoid cracking)
Fig.9.1
and offer door into position.
Check the door frame is level, vertical and square on all sides of the opening,
checking to ensure the door is not leaning forward or backwards in the opening.
Fig. 9.2.
Frame MUST NOT
be twisted or buckled when fitting. Adjust the door ensuring frame is vertical using the adjustment screws as
per stage 6.and GENTLY tighten frame into opening ensuring sides of door frame are not distorted by
over-tightening. Fix door using 6 x No.8 Panhead 60mm screws provided. The middle screws may now be
adjusted to assist in plumbing the door frame. Be sure not to over tighten the middle screws
(finger tighten only) as this may cause "bowing" of the wall posts.
9
8.2
8.1
9.1
9.2
8
Mark holes through wall frame of door - 3 each side. Remove door and drill holes in wall using 7mm masonry
drill bit
Fig.8.2
Useful tip: For accuracy, to mark holes through wall frames, dip a drill bit in shoe polish and "
spot" the position through the wall frame mouldings.
Fig. 8.1
10
Re-fit clip-in extrusions, which were removed in stages 4 & 5.
Ensure the correct Clip-in extrusion is re-inserted in its correct
side. Do make sure the leading edge is properly located along
full height before pressing the Clip-in extrusion into the door
frame, it will not locate properly if twisted.
Fig. 10.1
shows the
handle side and
Fig. 10.2
shows the fixed panel side.
10.2
10.1
LEADING EDGE
