11
16
Slide fixed panel back to its original
position before stage 3. Ensure the
rigid gasket on the glass edge slots
into the groove along the clip in
extrusion (failure to do so may result
in leaks). Screw patches to frame with
4 screws removed in stage 3 and fit screw
cover caps.
Fig. 11.1 & Fig. 11.2
11.1
SLIDE
BACK
11.2
RE-FIX SCREWS
SLOT GASKET LIP IN
GROOVE IN FRAME
12.2
12.3
12.4
SEAL
THIS JOINT
OUTER FACE
LEFT & RIGHT
12.1
PHOTO SHOWING
PATCH FITTING SCREW
Using 2.5mm allen key, position and fix door
stops in top and bottom frame to prevent the
sliding door banging into the wall frame
17
18
Silicone seal the Vertical wall posts to the tiles on the inside and the
outside, then silicone seal the enclosure to the tray on
Outside Only
Do not silicone seal on the inside of unit
.
Sealing the wallposts & sills to the tray on the inside can result in
leakage problems- please note that, in use, water can penetrate into
the frame extrusions-
this has no detrimental effect to the
product
-
however, this water must be allowed to drain out of the extrusions
to the inside.
12
CHECK HANDING OF SLIDING DOOR-
Stand door upright so that the lever patch fittings are at the
bottom and the outside face of door is facing you. If the door handle is on the correct side to suit your
installation, proceed to next stage.
If not
, simply remove lever patch fittings and plastic seal from bottom of door and re-fit these to top of door
(levers to point to centre of door). Turn door upside-down to complete.
TIP
Slide door stop-blocks to fixed panel wallpost before carrying out next stage.
13
FIT SLIDING DOOR,
hang the wheeled patches in the top rail, carefully feed sliding door through opening
and fit door to ‘roller’ patch fittings using inner covers and screws. Ensure shoulders of patch fittings are tight
against top edge of door.
TIP
If working alone, have allen key, ‘roller’ patch inner covers and screws on your person before fitting sliding
door. Use foot to support door when fitting.
14
LUBRICATE BOTTOM RAIL,
apply vaseline/lubricant spray to running channel on bottom rail.
15
ENGAGE BOTTOM LEVERS,
with
levers constantly pressed
down,
engage into bottom rail and slide
door from side to side. If sliding tight, lower relevant lever patch fitting on door glass, re-tighten screw, until
patches slide free.
FIT GLAZING SEALS
to fixed panel glass on outside of unit. Insert long
length between clip-in extrusion and glass. Insert short lengths between rails
and glass at top and bottom, in-between patch fittings.
TO GAP
T
O GLASS
GLAZING
SEAL
TIP
If tight, lubricate seals with water. Do not stretch seals when inserting-after
cutting, the seals will shrink and leave a gap.
Adjust the hanging of the door so that the
closing edge of the glass meets the closing seal
evenly over it’s entire height. Please see the
guide to adjustments
Fig12.1
Gain access to
screw “A” by removing the top patch cover
Fig
12.2
.
SLIDING DOOR
VIEW
FROM INSIDE
TOP
TO RAISE THIS
SIDE OF DOOR
USE SCREW
‘A’
TO LOWER
THIS SIDE OF
DOOR USE
SCREW ‘B’
A
B
TO RAISE THIS
SIDE OF DOOR
USE SCREW
‘A’
TO LOWER
THIS SIDE OF
DOOR USE
SCREW ‘B’
A
B
PLEASE ENSURE THAT AFTER ADJUSTMENT
ALL SCREWS ARE FULLY TIGHTENED
V10.02
