Kubota WSM STa-30, Workshop Manual

Page: 221 / 359

6-S6
ST
α
-30 · ST
α
-35, WSM FRONT AXLE
[2] DISASSEMBLING AND ASSEMBLING
(1) Separating Front Axle Assembly
Draining Front Axle Case Oil
1. Place the oil pans underneath the front axle case.
2. Remove the both right and left hand side drain plugs (1) and
filling plug (2) to drain the oil.
3. After draining, reinstall the drain plugs (1).
4. Fill new oil with specified amount of oil.
IMPORTANT
■
• Use KUBOTA SUPER UDT fluid or SAE 80, 90 gear oil.
Refer to “LUBRICANTS, FUEL AND COOLANT”. (See page
G-8.)
W1012110
Propeller Shaft
1. Loosen the clamp (1) and slide the propeller shaft cover (2).
2. Tap out the spring pin (3) and then slide the coupling (4).
3. Remove the propeller shaft with cover.
(When reassembling)
• Apply grease to the splines of the propeller shaft and couplings.
• When inserting the spring pins (3), face their splits in the direction
parallel to the universal joint as shown in the figure.
W1012396
Front axle case oil capacity
4.0 L
1.06 U.S.gals.
0.88 Imp.gals.
(1) Drain Plug (2) Filling Plug with Dipstick
(1) Clamp
(2) Propeller Shaft Cover
(3) Spring Pin
(4) Coupling A : Approx. 1.0 mm (0.039 in.)
B : Split Portion
KiSC issued 11, 2006 A