Kubota M5-091, Operator'S Manual

Page: 122 / 176

PERIODIC SERVICE 98
EVERY 400 HOURS
B
Cleaning Water Separator
This job should not be done in the field, but in a clean
place.
1. Disconnect the connector of water sensor.
2. Close the fuel shutoff-valve.
3. Unscrew the cup and remove it, then rinse the inside
with kerosene.
4. Take out the element and dip it in the kerosene to
rinse.
5. After cleaning, reassemble the water separator,
keeping out dust and dirt.
6. Connect the connector of water sensor.
7. Bleed the fuel system.
(See "SERVICE AS REQUIRED" in "PERIODIC
SERVICE" section.)
A If the water separator and/or fuel filter is not well
maintained, the supply pump and injector may be
damaged earlier than expected.
B Lubricating Grease Fitting [2WD Model]
Detach the cover, and apply bearing grease.
EVERY 500 HOURS
B
Changing Engine Oil
To avoid personal injury or death:
A
Be sure to stop the engine before changing the
oil.
A
Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. To drain the used oil, remove the drain plug at the
bottom of the engine and drain the oil completely into
the oil pan.
2. After draining reinstall the drain plug.
3. Fill with the new oil up to the upper notch on the
dipstick.
(See "LUBRICANTS" in "MAINTENANCE" section.)
A
Use DPF-compatible oil (CJ-4) for the engine.
(1) Water sensor connector
(2) Fuel shutoff-valve
(3) Cup (A) "CLOSE"
(1) O ring
(2) Element
(3) Element cup
(4) Red float
(5) Cup
(6) Drain plug
(7) Water sensor connector
(1) Front wheel hub cover
Oil capacity with filter 10.7 L (11.3 U.S.qts.)